Up to 12 total axes, with 6 axes simultaneous.
Even experienced programmers hit "alarm" states. The Fanuc manual’s Alarm List is the most critical resource. Here are three frequent alarms on the Oi-TF Plus and their manual solutions:
| | Primary Focus | Best For | | :--- | :--- | :--- | | Programming Manual (B-64694EN series) | Detailed explanations of G-code, M-code, and canned cycles. It includes the syntax, format, and use of every command. | The primary reference for writing and understanding G-code programs. | | Operator's Manual (B-64694CM series) | Daily operation of the CNC machine. Covers powering on/off, control panel functions, program management (load/edit/run), and manual machine control (JOG, MPG). | Machine operators, setup personnel, and anyone new to using the control. | | Parameter Manual (B-64692EN series) | Describes each system parameter that controls the CNC's behavior, machine configuration, and option selections. | Advanced users, maintenance engineers, and machine tool builders for configuring and optimizing the control. | | Connection Manual (B-64693EN series) | Technical details for hardware installation, including the connection of power, servos, I/O devices, and other electrical components. | Machine tool builders and service technicians for installation and electrical troubleshooting. | | Maintenance Manual | Procedures for preventative maintenance, troubleshooting alarms, replacing components, and keeping the control in optimal condition. | Maintenance personnel and advanced service technicians. | fanuc series oi-tf plus programming manual
: Enhances surface finish quality through advanced interpolation.
When using CSS ( G96 ), the control will attempt to spin the chuck infinitely fast as the tool approaches the center point ( Up to 12 total axes, with 6 axes simultaneous
is a high-performance CNC system specifically optimized for modern lathe and turning applications. Its programming manual serves as the primary technical guide for both traditional G-code (ISO) and advanced conversational programming.
When turning contours, the tool has a small radius at its tip. Without compensating, this radius will leave a tiny amount of material, leading to inaccuracies on chamfers, tapers, and arcs. Tool Nose Radius (TNR) compensation uses the G41 (left side) and G42 (right side) commands to adjust the toolpath automatically, ensuring the part matches the program exactly. Here are three frequent alarms on the Oi-TF
The Series 0i-TF Plus focuses on reducing cycle times and improving surface quality through several advanced functions:
Turns off compensation. Always cancel G41/G42 during a rapid move away from the workpiece to prevent erratic tool paths. 6. Custom Macro B Programming