Xnx Universal Transmitter Quick Start Guide Jun 2026

: If fitted with the optional relay module, contacts are rated at 250 VAC 5A or 24 VDC 5A (resistive loads only). file.yizimg.com 4. Sensor Installation (Plug-in) To install or replace a sensor:

The XNX utilizes a magnetic user interface, allowing you to navigate menus and change settings without opening the enclosure. This keeps the explosion-proof integrity intact during operation.

: Ensure the housing O-ring is intact and lubricated. 2. Mechanical Mounting Xnx Universal Transmitter Quick Start Guide

Allow at least 6 inches (150 mm) of clearance below the sensor for easy cartridge replacement. Electrical Wiring and Connections

Route your power cable through the chosen conduit entry. Connect the positive line to Terminal 1 (24V DC +) and the negative line to Terminal 2 (Common) . : If fitted with the optional relay module,

Let me know which direction you’d like to go — upload or paste the guide text, and I’ll produce the full report for you.

Steps progress naturally:

Mount the transmitter so that the attached sensor faces downward. This prevents water or dust from accumulating on the sensor face.

Once wiring is verified and the enclosure cover is tightly closed, apply 24V DC power. Boot Sequence Mechanical Mounting Allow at least 6 inches (150

Thread the sensor retainer ring clockwise until hand-tight to seal the weatherproof joint. User Interface and Navigation