Hdl Buspro Setup Tool 2 Info

Re-open the button target list. Double-check that the actuator's actual Subnet and Device ID match the target exactly. Using the Bus Monitor

To help refine your system profile or address specific programming hurdles, please let me know:

Have you encountered any specific challenges using the new Setup Tool? Share your troubleshooting tips in the comments below! hdl buspro setup tool 2

Double-click on any discovered device (e.g., a 6-key panel) to open its configuration window.

If a device shows up with an address conflict (highlighted in red), right-click it to assign a unique Subnet/Device ID. Step 3.3: Configuring an Actuator (Relay/Dimmer) Re-open the button target list

Connect your computer to the same network as the HDL TCP/IP interface.

Modern buildings are rarely homogeneous. The Setup Tool 2 facilitates integration via gateway devices (e.g., BACnet, Modbus, KNX, or MQTT). While the tool itself configures HDL-side behavior, it allows mapping of external points into Buspro logic. For instance, a Modbus energy meter can be linked to a Buspro relay to shed non-critical loads during peak demand. Share your troubleshooting tips in the comments below

Scenes allow you to trigger multiple channels across different modules to specific levels simultaneously.

: It supports backing up and restoring device data, as well as performing online or manual firmware upgrades.

HDL Buspro does not live in a bubble. The Setup Tool 2 allows integration setup for:

Select , choose your local network interface card (NIC), and enter the IP address of your Buspro Gateway.