Simrad Rf300 Installation Manual Verified [ Firefox ]

Adjust the length of the threaded transmission rod so that it fits perfectly between both ball joints while both the rudder and the RF300 remain perfectly centered.

: Variable frequency signal (square wave) read directly by Simrad/Robertson autopilot computers. Simrad Commercial Setup & Calibration

The sensor has a small LED indicator and a calibration button. The manual notes that you need access to these during setup. Mount the unit where you can see the LED while standing at the helm or using a remote display.

While looking at the autopilot display, turn the helm slowly from side to side. simrad rf300 installation manual

Secure the RF300 base to the mounting platform using stainless steel screws. 3. Assemble and Adjust the Linkage Rod

Route the cable from the rudder compartment to the autopilot computer. Avoid routing parallel to high-current cables, radar cables, or VHF antenna lines to prevent signal interference. Strip the outer insulation of the cable carefully.

Verify the unit's operation by turning the helm from hard-over to hard-over to ensure the linkage moves freely and the feedback value changes correctly on the display. Adjust the length of the threaded transmission rod

:

The transmitter arm has two slots for the linkage. Choose the slot that allows for maximum flexibility and ensures the rod moves freely throughout the full range of rudder movement.

The RF300 must mount close to the rudder stock, mechanically linked to the rudder tiller arm or quadrant. Do not mount it to the boat's hull or bulkhead if it is not aligned with the rudder post. The manual notes that you need access to these during setup

The Ultimate Simrad RF300 Installation Guide: Step-by-Step Rudder Feedback Setup

Check for broken wiring or loose connections in the feedback unit or the autopilot computer.

Once mechanics and electronics are secured, you must calibrate the rudder feedback unit through your Simrad autopilot controller (e.g., AP24, AP44, or an NSS/NSX/NSO multifunction display). Step-by-Step Software Calibration

When you open the box, the lists the following standard items:

I can then provide the exact and specific dockside setup parameters for your exact setup. Share public link