Download Link [top] | Infineon Memtool
(Invoking related search terms.)
If you just need to flash a single Infineon chip, use (part of DAVE) or J-Flash (from Segger) – both are free and safe.
MEMTool is Infineon’s Windows utility for programming and testing certain Infineon MCU/memory devices (firmware flashing, memory inspection, etc.). Use only official downloads and follow device-specific instructions from Infineon.
Memtool provides comprehensive support for a vast portfolio of Infineon hardware, including: infineon memtool download link
No, the free Infineon Memtool does not support a command-line interface (CLI) for automation. This feature is only available in the commercial PLS Memtool product.
Connect your hardware debugger (e.g., an Infineon miniWiggler) to your PC via USB, and connect the JTAG/DAP ribbon cable to your target evaluation board. Power on the target board. Step 2: Configure the Target Device Open the Memtool GUI application. Go to > Change... in the menu bar.
You will need a registered Infineon account (myInfineon) to initiate the download. Registration is free and grants access to datasheets, user manuals, and software updates. (Invoking related search terms
menu to browse and select the specific configuration file for your evaluation board or MCU. Programming : Open your Intel-Hex file and use the buttons to flash the memory. configure a specific target (like an AURIX TC3xx) within the MemTool interface? Memtool v3 for C164SI - Infineon Developer Community
Memtool requires a hardware adapter to bridge your PC to the microcontroller. Supported miniWiggler, J-Link, or onboard debuggers should be plugged into your PC via USB before launching the software. 3. Select the Target Configuration
A critical point to remember is the licensing and intended use of the free Memtool. Memtool provides comprehensive support for a vast portfolio
: Includes pre-configured files for Infineon evaluation boards and application kits to simplify the initial setup. Infineon Developer Community Brief Operational Guide Select Target : Navigate to Target -> Change and browse for your specific microcontroller derivative. Configuration
Click the button on the main toolbar. Memtool will initialization communication with the target. If successful, the status bar at the bottom will display "Connected" and show the detected Chip ID. Step 4: Open the Firmware File Click File > Open or use the Open File icon.