V2000-c Rfid Access Control User Manual | No Login |

Connect the wire of the V2000-C and the Negative (-) terminal of the lock to the Power Supply GND.

The V2000-C is a 125KHz RFID standalone access control keypad designed for single-door security, supporting up to 1,000 users with card or PIN access. Programming involves entering a master code to add/delete users, configure door open times, and manage system settings. Official digital copies of the V2000-C User Manual are available at www.goldbridgesz.com V2000-c Rfid Access Control User Manual

⚠ Change the master code immediately after first installation. Connect the wire of the V2000-C and the

Connect the wire of the V2000-C to the Power Supply +12V. Official digital copies of the V2000-C User Manual

The anti-tamper switch is located at the bottom right corner of the circuit board. When closed, the alarm is silent. When opened (cover removed), the buzzer emits continuous short beeps.

If you cannot enter programming mode, you must reset the device to factory defaults. Power off the unit, press and hold the exit button, power on, and wait for the beeps.

Secure the back panel to the wall using the supplied wall anchors and screws. Attach Unit: Pass the wiring through the cable hole and attach the unit to the back panel. 3.2 Wiring Diagram uses a color-coded wire harness: Red: +12V DC Power Input Black: GND (Ground) Blue: NO (Normally Open) Yellow: NC (Normally Closed) White: COM (Common) Green: Exit Button (Button 1) Gray: Door Contact (Optional) Purple: Alarm (Optional)