Gilbarco Sk700 Programming Manual 🎯 Fully Tested

and often requires specific security codes depending on the access level required. Core Programming Codes & Access

Indispensable for maintaining SK700s, but dangerously silent on modern safety and integration practices. Use as a repair reference, not a system design guide.

| Parameter 76 + Function Code | Task | | :--- | :--- | | FC 1 | : The process of calibrating a meter using a prover can. | | FC 2 | Read/Write Calibration Factor : Allows a technician to manually view or input a specific calibration factor for a meter. | | FC 3 | Calibration Switch Assignment : Used to check which calibration switch corresponds to which meter. |

| ✅ Item | Why | |--------|-----| | Verify display correctly on the pump UI. | Prevents customer complaints. | | Run a test dispense (e.g., 0.1 gal) and check the printed receipt. | Confirms the nozzle‑grade‑price chain. | | Capture a configuration backup and label it with date, pump ID, and revision. | Provides a rollback point. | | Document any password changes in the service log. | Maintains audit trail for compliance. | | Ensure the service cable is removed and the port cover is re‑installed. | Prevents accidental re‑programming. | | Record the firmware version in the site logbook. | Helpful for future support tickets. | Gilbarco Sk700 Programming Manual

The SK700 is not a "plug-and-play" device. It operates using a that communicates with a site controller (like a Gilbarco G-SITE or Passport) or runs in standalone mode. Programming the SK700 involves configuring three core areas:

If an error code persists after basic troubleshooting, contact a qualified Gilbarco service technician, as deeper diagnostics may be required.

Parameter 76.1 is the starting point for checking and adjusting a meter's accuracy using a prover can. The procedure is as follows: and often requires specific security codes depending on

: Familiarize yourself with the communication protocols supported by the SK700, such as RS232, Ethernet, etc.

You are now in manager mode, allowing you to use command codes for configuration. 2. Essential Command Codes and Procedures

After the reboot, basic parameters like Country Code, Pump Type, and Protocol must be set. Reference Manuals Installation & Commissioning Manual: Available at Gilbarco Australia , covering setup and initial codes. Programming Guides: | Parameter 76 + Function Code | Task

Display volume correction factors.

If you operate or service a site with an SK700 console, . It is more than a user guide—it’s a compliance tool, a safety document, and a troubleshooting lifeline.

This diagnostic parameter is used to check which meters are assigned to which hoses and to see if their calibration switches are open or closed.

The display will show a 0 , indicating the unit is ready for a Function Code (FC) or Command Code (CC). 3. Essential Command Codes (CC)

When programming parameters incorrectly, the dispenser will trigger error messages on the main display matrix. Error Code E11: Pulser Error